How To Remove Push Lock Fitting From Plastic Tubing?

How do you remove a push lock hose?

Remove push-lock hose with a soldering iron. That’s right, instead of using a knife to do the job, take a soldering gun and put a plastic cutting tip on it. Next, bend it 90 degrees so it acts like a cutting blade. Then, after letting it heat up, slowly use it to cut down the hose.

Can you disconnect push to connect fittings?

Removing SharkBite Fittings Unlike other fittings, SharkBite brass push-to-connect fittings can be removed and re-used if changes are necessary. To remove the fitting, use a SharkBite Disconnect Clip or Disconnect Tongs. To use the Disconnect Clip, snap it on to the pipe and pull up to the release collar.

Can you reuse push lock fittings?

What’s more, Push-Lok fittings are reusable. Just replace the hose at the job site without any special tools or clamps. Helping you maintain a clean environment on the job is another important reason to use Parker’s Push-Lok system.

What is the life expectancy of a SharkBite fitting?

How long do SharkBite fittings last? SharkBite fittings last a long time. In fact, SharkBite warrants the fittings for 25 years when used with SharkBite tubing.

Do you take plastic out of SharkBite fittings?

You do not want to damage the teeth inside the SharkBite fitting. This is the reason why we decided to leave the plastic pex tube liner in when installing SharkBite fittings and connectors on copper pipe. We do not remove them. If you need to remove a fitting, follow the manufacturers instructions here.

Leave a Reply

Your email address will not be published. Required fields are marked *